External Grip Warmer Kit Heated Grips for Motorcycle and Electric Bike

Fits all Motorcycles and Electric Bikes, regardless of handlebar size
Two (2) adhesive external grip heaters
Comes with a 2-position (off,on) rocker switch
Maximum 20 watts (10 watts per heater) at 12 volts

Net weight: 75g

Gross weight: 82g

Material: :PET Metal Heating Film

Size: Length: 9.5cm;
Width: 8cm
Input voltage: 12V
Power: 10W + 10W
Hand temperature: Low temperature: 30 degrees C;
Switch Type: Ship type waterproof waterproof, dust switch
Accessories: left and right grips, a pair of heat shrink casing;a waterproof insulation tape; a user manual

Advantage:

1 Easy modification, that is, non-destructive appearance, and easy to operate, installation is very simple
Pet metal heating film, heating speed is very fast, a few seconds of heat, safe and fast
3. Use of ship-type switch, waterproof, dust-proof, beautiful and safe
Switch design, can be directly installed on the rear view mirror seat, no punching, no damage, very simple

5 DC 12V input, suitable for all motorcycle use, a wide range of use
Installation method: Put the electric heat ingress on the torch and adjust it to the right position
With tape uniform lym melee fixed (tangent) to the handlebars, especially in the wiring of the electric heat sheet to be closely wound
Three: put on the sleeve, adjust the position, with a hot air gun (can also be used lighter or hair dryer) to be vertically symmetrical blowing jacket tube two creases until the contraction is uniform, and then evenly blow other parts, until the parts of the coat tube shrink evenly, flat until
The switch is installed under the mirror rod of the rear view mirror Five: pick up the power cord, red line, black line regardless of positive and negative, but be sure to receive the electric door lock (where the key is inserted) the lower pole output line